The injection molding process requires the use of an ”injection molding machine”, ”raw plastic material”, and a ”mold”. The plastic is melted in the injection molding machine and then injected into the mold, where it cools and solidifies into the final part. The steps in this process are described in greater detail in the next section.

What is the difference between hot runner and cold runner injection molds? Compare cost, material waste, cycle time, maintenance and production efficiency to choose the right runner system for your plastic injection mold.

Taking your mold from good to great is as simple as testing it via Mold Flow Analysis (MFA). This software simulates your mold conditions before you open up your wallet to pay for tooling. The effect MFA has on the quality of the mold, the performance and appearance of your product makes it an indispensable component of any plastic injection molding design project.

Manufacturing a mold is not easy, there are many things to pay attention on, so you need to try to find a good mold supplier to make your money worth for this investment.

Plywood is a panel consists of some plies of veneers. The veneers are peeled from wood logs, like hardwood, birch, poplar, oak, pine, etc.These wood veneers finally will be bonded together with adhesive under high pressure and high temperature (110℃ to 140℃).

There are two ways to make two-color products, one is over moulding by 2-step injection, the other is double injection by single step, which includes using rotary table or axis to make two-color plastic injection products.