Plastic Watering Can Shower Head Mold

Focare Mould developed this plastic watering can shower head mold project for a two-part watering accessory. The molded assembly consists of the perforated shower-head section and a separate body that connects to the watering can spout.

The product is intended to distribute water through multiple openings. The final spray pattern, flow behavior, connection method, and fit depend on the customer’s approved product design; they are not fixed mold-performance specifications.

Two-Part Watering Can Nozzle Design

The shower head and body should be reviewed as a complete assembly. Their connection geometry, contact areas, orientation, and dimensional relationship affect how the finished parts fit together and connect to the watering can.

The customer should provide complete drawings for both components. Focare Mould can then review the parting directions, undercuts, inserts, gate positions, cooling, and ejection requirements for each part.

Body Mold with Two Sliding Blocks

For the existing watering can nozzle body project, the original mold information records two sliding blocks driven by inclined guide pillars during mold opening. This arrangement releases the body geometry before the molded component is removed from the core area.

The two-slider structure is specific to this product design. A new watering can nozzle injection mold may require a different core-pulling solution depending on the connector shape, undercuts, wall geometry, and release direction.

Insert Structure for Machining and Maintenance

The original body mold uses inserted cavity and core areas. Separating selected molding details into inserts can support machining access, assembly, inspection, and future maintenance when the product geometry makes an integral structure less practical.

Insert boundaries, locking, cooling access, venting, and parting-line locations should be reviewed against the approved product. Focare Mould does not assume the same insert arrangement for every watering-can spray-head mold.

Air-Blow Release for the Molded Body

The existing project information also records air-blow assistance after ejection so the molded body can release from the mold. Air assistance should be coordinated with the mechanical ejection sequence, product shape, draft, shrinkage, and machine controls.

Whether air-blow release is appropriate for a new product must be confirmed during mold design and trials. The page does not claim automatic release for products that use a different geometry or resin.

Perforated Shower Head Mold Opening

The perforated shower-head component contains multiple small water openings. These features should be reviewed for machining, venting, filling, cooling, and release. The approved opening geometry is defined by the product drawing rather than by a generic spray-head specification.

For the original project, the cavity-side insert is released during an initial mold-opening movement before the main parting surface opens. The ejector plate then removes the shower-head component. This staged action helps address the recorded product geometry but must be reassessed for any new design.

Gate, Cooling, and Appearance Review

Gate position and runner design should support filling of the connector body and perforated face without interfering with important assembly or visible surfaces. Cooling layout should be coordinated with the inserts, sliders, and small molded features.

Parting lines, gate marks, flash around the openings, and the fit between both components should be included in the project acceptance review. No fixed cavity quantity, steel grade, runner system, cycle time, or performance result is assumed without customer data.

Information Needed for a Watering Can Spray Head Mold

For evaluation, please provide:

• Complete drawings or 3D data for the shower head and body

• Confirmed resin grade and connection requirements

• Required appearance and component-fit standards

• Injection molding machine information

• Mold-trial and sample-acceptance requirements

Work with a China Mold Maker

This page focuses on plastic shower-head and connector molds for watering cans. Focare Mould also supports buyers seeking a Plastic Injection Mold Maker China partner and an experienced China Mold Maker for customized household and garden plastic products.

Watering Can Shower Head Mold Video