• Plastic Tea Bottle Cap Injection Mould

    Plastic Tea Bottle Cap Injection Mould

    The general water bottles are round and sometimes take space in the bags, but these water bottles are square. If they are placed properly, they can save a lot of space inside your bag.

    Read More
  • Plastic Flip Top Lotion Caps Injection Mould

    Plastic Flip Top Lotion Caps Injection Mould

    Most of the plastic flip top caps mould are designed with two-time ejection structure. The core is pushed out two times. The stripper plate and the ejector sleeve in the middle of the product are pushed out together to 14mm, and then the stripper plate push out continually until the flip top caps drops.

    Read More
  • Cap of Laundry Detergent Bottle Mould

    Cap of Laundry Detergent Bottle Mould

    Each cavity of this cap mold is designed with separate inserts, so that each cavity product in the process of injection molding maintain the same injection molding pressure, clamping force and other molding conditions, so that the product quality is more stable and reliable. Moreover, the independent insert design can make the life of the mold longer. If there is any problem with the parts, the parts can be directly replaced without affecting the production schedule.

    Read More
  • Oil Bottle Plastic Cap Plastic Injection Mould

    Oil Bottle Plastic Cap Plastic Injection Mould

    The unscrewing device of this cap mold is hydraulic motor. The ejecting sequence of this cap mold is to let the upper press plate open the mold first, and rely on the I-shaped block to drive the cavity slider to slide away. The mold is opened to a certain stroke, and the caps will be unscrewed by hydraulic unscrewing motor. The left and right thimble plates are performed simultaneously. The spring is pushed out of the barrel by the force of the spring, so that the product is firmly in the core part. After opening the mold, the oil cylinder pushes the rack, drives the central drive shaft, drives 4 product threaded shafts backward to disengage the product, and then relies on the 2 ejector rods on the outside of the machine, and the ejection plate pushes caps off from mold.

    Read More
  • Square Flip Top Sampoo Cap Plastic Injection Mould

    Square Flip Top Sampoo Cap Plastic Injection Mould

    Flip top shampoo cap is one-time use of large-scale production product. Normally, after injecting, there is no more surfaces processing, and it can directly enter the subsequent automatic packaging. Therefore, the appearance of the flip top shampoo cap is required to be high, and there are no obvious molding defects.

    Read More
  • Plastic Cap of Liquor Bottle Injection Mould

    Plastic Cap of Liquor Bottle Injection Mould

    Plastic liquor caps are different from the ones we usually use. They are not sealed by threads or barbs like plastic caps of mineral water bottles, but by oak plugs. However, the oak plugs may cause decay or cracking after long-term and long-distance transportation or weather, plastic caps are needed to keep them sealed and protect oak plugs.

    Read More
Please feel free to give your inquiry in the form below. We will reply you in 24 hours.
* Email :
Company :
  • Name :

  • Phone:

Message :